Cycle977 Workpiece: Measure Hole/Shaft/Groove/Web/Rectangle Parallel To Axes; Function Overview - Siemens SINUMERIK 840D sl Programming Manual

Measuring Cycles for Milling and Machining Centers

5.4 CYCLE977 workpiece: Measure hole/shaft/groove/web/rectangle parallel to axes

5.4 CYCLE977 workpiece: Measure hole/shaft/groove/web/rectangle
5.4
parallel to axes
5.4.1

Function overview

Function
With this measuring cycle you can measure the dimensions of the following contour
elements on a workpiece using different measuring variants:
• Hole
• Shaft
• Groove
• Web
• Inside rectangle
• Outside rectangle
Measurement is performed paraxially to the workpiece coordinate system.
In some measuring variants defined safety zones are taken into account during the
measuring operation.
CYCLE977 can
• measure the contour elements
and additionally either
• perform an automatic tool offset
for a specified tool based on the differences in diameter or width, or
• a zero offset (ZO) based on the differences between the center positions.
5-48
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles