Example 1 - Siemens SINUMERIK 840D sl Programming Manual

4.2.9.2

Example 1

Measurement
4 holes were measured. An offset is applied in a ZO that was not active during
measurement. Reorientation of the probe is not necessary. The following selection display
appears with information:
Explanations on selection display
The display for the measurement function "measure 4 holes" is shown in the left part of the
screen form. The display of the measurement result is also shown in the WCS that was
active during measurement (G500) and display of the translation values of the offset ZO.
The operator is informed about the selection made in the selection field (yes) with a text or in
an upper image line:
• "You have applied an offset in a non-active ZO!"
A message text also appears for the special case:
• "The WCS is about the ...".
An additional text is output on the HMI "dialog line with user information and instructions. It
provides instructions on action to take:
• "Please press NC start to activate!"
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring in JOG
4.2 Workpiece measurement
4-39