Measuring Cycles For Turning Machines; General Prerequisites; General Information; Overview Of Measuring Cycles - Siemens SINUMERIK 840D sl Programming Manual

Measuring Cycles for Turning Machines

6.1

General prerequisites

6.1
6.1.1

General information

The measuring cycles below are intended for use on turning machines.
To be able to run the measuring cycles described in this Chapter, the following programs
must be stored in the part program memory of the control.
6.1.2

Overview of measuring cycles

Cycle
(CYCLE972)
CYCLE973
CYCLE974
CYCLE982
CYCLE994
1) CYCLE982 is the preferred cycle to use. CYCLE972 does not support graphic measuring cycles
6.1.3

Overview of the auxiliary programs required

Cycle
CYCLE100
CYCLE101
CYCLE102
CYCLE103
CYCLE104
CYCLE105
CYCLE106
CYCLE107
CYCLE108
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Function
Calibrate tool probe, measure turning tools
1)
Calibrate workpiece probe in the reference groove or on surface
1-point measurement with automatic tool offset or ZO determination
Calibrate tool probe, measure turning and milling tools
2-point measurement on diameter with automatic tool offset
Function
Log ON
Log OFF
Measurement result display selection
Preassignment of input data
Internal subroutine: Measuring cycle interface
Generate log contents: Log
Logging the sequential controller Log
Output of message texts (up to measuring cycles SW 6.2)
Output of alarm messages (up to measuring cycles SW 6.2)
6
6-1