Advertisement
3570
Reference Code
Description/Action Perform all actions before exchanging Failing Items
9302
I/O processor Licensed Internal Code error
If the system is operational, take a dump of the I/O processor data. For
more information, see the iSeries Service Functions information or ask your
next level of support for assistance.
9303
Gateway device failure
Use the gateway device service documenation to analyze the problem.
9310
Licensed Internal Code for the tape unit is not correct
9320
Tape device Licensed Internal Code failure
Perform the following:
1. Take a dump of the tape unit Licensed Internal Code (see the 3570 Tape
Unit service information).
2. Power off the tape unit. Then power on the tape unit to resume
operation.
3. Ask your next level of support for assistance.
9321
Gateway device Licensed Internal Code error
Use the gateway device service documenation to analyze the problem.
9350
Tape unit detected a read or write error on tape medium
A permanent read or write error occurred, and the tape unit determined
that the tape cartridge is defective. Exchange the tape cartridge.
9351
Tape with excessive error rate was mounted in tape device.
The tape unit detected that the mounted tape cartridge has a history of
excessive read and write errors. It is recommended that you exchange the
tape cartridge.
9355
The data format is incorrect; the tape cannot be read
The tape unit does not give support to the data format on the tape
cartridge. Use a different tape cartridge.
9500
I/O processor Licensed Internal Code error
If the system is operational, take a dump of the I/O processor data. For
more information, see the iSeries Service Functions information or ask your
next level of support for assistance.
9800 to 9803
I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
9810
Problem analysis has determined a part should be replaced.
This reference code is used for ending Online Problem Analysis with a list
of failing items. (Information Only)
9899
Problem analysis completed, the problem has been corrected.
This reference code is used for ending Online Problem Analysis when no
problem was found or the problem was corrected.
166
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
Failing Item
FI00130
FCGATE
DHZDEV
FI00130
FI00130
DHZDEV
FCCODE
MHZTMED
UHZCLN
DHZDEV
MHZTMED
UHZCLN
DHZDEV
UHZUSER
MHZTMED
UHZCLN
DHZDEV
FI00130
UHZFIXD
Advertisement
