Cruise Control Indicator Light; Cruise Control Set Indicator Light - Subaru 2008 TRIBECA Owner's Manual

! To decrease the speed (by brake
pedal)
1. Depress the brake pedal to release
cruise control temporarily.
2. When the speed decreases to the
desired speed, press the control lever
downward in the "SET/COAST" direction
once. Now the desired speed is set and
the vehicle will keep running at that speed
without depressing the accelerator pedal.
& Cruise control indicator light
The cruise control indicator light comes on
when the ignition switch is turned to the
"ON" position and goes out after approxi-
mately 3 seconds.
The light comes on when the "CRUISE"
main switch is pressed.
If you move the cruise control lever while
turning the ignition switch "ON", the cruise
control function is deactivated and the
"CRUISE" indicator light flashes. To re-
activate the cruise control function, turn
the ignition switch back to the "Acc" or
"LOCK" position, and then turn it again to
the "ON" position.
& Cruise control set indicator
light
The cruise control set indicator light
comes on when the ignition switch is
turned to the "ON" position and goes out
after approximately 3 seconds.
The light comes on when vehicle speed
has been set.
7-33
Starting and operating