Position Of Rear View Camera; How To Use The Rear View Camera; Viewing Range On The Screen - Subaru 2008 TRIBECA Owner's Manual

6-22
Interior equipment
& Position of rear view camera
It is attached to the rear gate.
& How to use the rear view
camera
! To display the rear view camera
image
When the selector lever is set to "R", the
rear view camera automatically displays
the rear view image from the vehicle.
When the lever is set to other positions,
the image before setting to "R" is dis-
played.
1. Set the ignition switch to "ON".
2. Set the selector lever to "R".
NOTE
The image of the rear view camera
has priority over other screen displays.
The image of the rear view camera is
horizontally reversed as is the case
with the vehicle rearview mirror or the
side view mirror.
If the lens of the camera is dirty, it is
difficult to see the image. Carefully
remove the raindrops, snow and dirt if
they are attached.
It is difficult to see the image of the
rearview mirror in the following cases.
This is not a malfunction of the camera.
The image may become poor
when the vehicle is in a dark place
(at night, in a tunnel, etc.) or an
extremely hot or cold place. This is
not a malfunction.
Strong light shined directly on the
camera lens may develop white
light stripes on the image. This is
not a malfunction.
While the rear view camera is in
operation, the operations of other
screens are disabled. To operate other
screens, set the selector lever to a
position other than "R". (Vehicle with
navigation system)
& Viewing range on the screen

! Viewing range on the screen

Range of view
Range of view