Security Indicator Light; Immobilizer System - Subaru 2008 TRIBECA Owner's Manual

Subaru 2008 tribeca sports utility vehicle owner's manual
Hide thumbs Also See for 2008 TRIBECA:
Table of Contents

Advertisement

The Vehicle Dynamics Control system
provides its ABS control through the
electrical circuit of the ABS system.
Accordingly, if the ABS is inoperative, the
Vehicle Dynamics Control system be-
comes unable to provide ABS control. As
a result, the Vehicle Dynamics Control
system also becomes inoperative, caus-
ing the warning light to come on. Though
both the Vehicle Dynamics Control and
ABS systems are inoperative in this case,
the ordinary functions of the brake system
are still available. You will be safe while
driving with this condition, but have your
vehicle checked at a SUBARU dealer as
soon as possible.
NOTE
If the warning light behavior is as
shown in the following, the Vehicle
Dynamics Control system may be con-
sidered normal.
The warning light comes on right
after the engine is started but goes out
immediately, remaining off.
The warning light comes on after
engine startup and goes off while the
vehicle is subsequently being driven.
The warning light comes on during
driving, but it goes out immediately and
remains off.
! Traction Control system OFF indi-
cator light
It comes on when the Traction Control
system OFF switch is pressed.
It also comes on when the Traction
Control system is deactivated.
NOTE
The light may stay on for a while
after the engine has been started,
especially in cold weather. This does
not indicate the existence of a problem.
The light should go out as soon as the
engine has warmed up.
The indicator light comes on when
the engine has developed a problem
and the CHECK ENGINE warning light/
Malfunction indicator lamp is on.
The Vehicle Dynamics Control system is
probably faulty under the following condi-
tion. Have your vehicle checked at a
SUBARU dealer as soon as possible.
The light does not go out even after the
lapse of several minutes (the engine has
warmed up) after the engine has started.
Instruments and controls
& Security indicator light
The indicators are located in the center
portion of the dashboard.
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
! Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to the "Alarm system"
section in chapter 2.

! Immobilizer system

This light blinks approximately 60 seconds
after the ignition switch is turned from
"ON" position to the "Acc" or "LOCK"
position or immediately after the key is
pulled out. (Refer to the "Door locks"
– CONTINUED –
3-19

Advertisement

Table of Contents
loading

Table of Contents