Subaru 2008 TRIBECA Owner's Manual page 106

2-12
Keys and doors
Programming transmitter codes into
system:
Bag containing transmitter
Transmitter circuit board
To register a new transmitter with the
keyless entry system, it is necessary to
program the transmitter's code (identifica-
tion number) into the system. A label
showing the code is affixed to the bag
containing the transmitter, and another is
affixed to the circuit board inside the
transmitter. If there is no bag, open the
transmitter case and make a note of the
eight-digit number. Program the number
into the system in accordance with the
following procedure:
1. Firmly close the doors and the rear
gate or trunk lid.
2. Open the driver's door, sit on the
driver's seat, and close the door.
3. Perform the following steps within 45
seconds.
(1) Open and close the driver's door
once.
1) LOCK
2) ON
(2) Insert the key into the ignition
switch, then turn it from the "LOCK"
position to the "ON" position 10 times
within 15 seconds.
NOTE
When you complete step (2), an
electronic tone will sound once, a
buzzer will continue to sound and the
interior light will continue to flash until
the transmitter codes are completely
registered.
If you do not perform steps (1) and
(2) within 45 seconds, an error will
occur. Neither an electronic tone nor
the buzzer will sound, and the interior
lamp will not flash. In this event, per-