Windshield Washer Fluid; Maintenance And Service - Subaru 2008 TRIBECA Owner's Manual

Subaru 2008 tribeca sports utility vehicle owner's manual
Hide thumbs Also See for 2008 TRIBECA:
Table of Contents

Advertisement

11-32

Maintenance and service

Windshield washer fluid

CAUTION
Never use engine coolant as washer
fluid because it could cause paint
damage.
If you spray washer fluid on the windshield
but the windshield washer fluid warning
light comes on or the supply of washer
fluid drops, check the level of washer fluid
in the tank.
Washer fluid level gauge
Remove the washer tank filler cap, then
check the fluid level indicated by the level
gauge (attached to the inside of the cap).
If the level is near the "Low" mark, add
fluid until it reaches the "Hi" level on the
level gauge.
After adding fluid, make sure the wind-
shield washer fluid warning light has gone
out.
Use windshield washer fluid. If windshield
washer fluid is unavailable use clean
water.
In areas where water freezes in winter,
use an anti-freeze type windshield washer
fluid. SUBARU Windshield Washer Fluid
contains 58.5% methyl alcohol and 41.5%
surfactant, by volume. Its freezing tem-
perature varies according to how much it
is diluted, as indicated in the following
table.
Washer Fluid
Freezing
Concentration
Temperature
30%
10.4 F (−12 C)
−4 F (−20 C)
50%
−49 F (−45 C)
100%
CAUTION
Never use engine coolant as washer
fluid because it could cause paint
damage.
In order to prevent freezing of washer
fluid, check the freezing temperatures in
the table above when adjusting the fluid

Advertisement

Table of Contents
loading

Table of Contents