Setting The Address Jumper (J1) - IBM RT PC Options Installation

Setting the Address Jumper (J1)

The following table shows the address ranges provided by jumper
J1. If two IBM RT PC SCSI Adapters are used, one must be
configured in the Primary J1 position and the other in the Alternate
J1 position. A single adapter can be configured for either address
range.
Note: Ensure that address ranges do not conflict with other
adapter options. Refer to "Conflicting Memory Addresses" on
page 1-19 for more information.
J1 Position Address Range
Primary 0D50 - 0D5F
Alternate 0950 - 095F
Section 8. Additional Options 8-11