Parallel Jumper Module - IBM RT PC Options Installation

Parallel Jumper Module

To change the parallel jumper module position, do the following:
1. Locate the bottom jumper module which sets the interrupt level
for the parallel connector.
2. Carefully insert a small, flat-bladed screwdriver under the
module and lift, alternating ends to lift the module evenly.
3. Rotate the jumper module to the desired position, and reinstall.
Installing: You may install this adapter in adapter slots 2 through
8 in IBM 6150 and in slots 1 through 5 in IBM 6151, whichever is
available. See the system unit diagram for the correct adapter slot.
Section 6. Communication and Network Adapter Options 6-9