Setting The Password Check Jumper (Jp1); Enabling Broadcom Netxtreme Gigabit Ethernet Boot Agent - IBM 6219 - IntelliStation M - Pro User Manual

Setting the password check jumper (JP1)

The following illustration shows the location of the password check jumper (JP1) on
the system board.
Password check
jumper
Complete the following steps to set the password check jumper (JP1):
1. Review the safety information beginning on page vii.
2. Turn off the computer and peripheral devices.
3. Disconnect all external cables and power cords; then, remove the cover. See
4. Move the jumper from pins 1 and 2 to pins 2 and 3. This clears the user
5. Connect the computer to a power source, keyboard, monitor, and mouse.
6. Turn on the computer.
You can now start the Configuration/Setup Utility program and either delete the old
password or set a new user password.

Enabling Broadcom NetXtreme Gigabit Ethernet Boot Agent

The Broadcom NetXtreme Gigabit Ethernet Boot Agent is part of the BIOS code
that comes with your computer. You can enable the Broadcom NetXtreme Gigabit
Ethernet Boot Agent from the Configuration/Setup Utility program. You can use the
Broadcom NetXtreme Gigabit Ethernet Boot Agent to configure the network as a
startable device, and you can customize where the network startup option appears
in your startup sequence.
(JP1)
Boot block
jumper (JP2)
"Turning off the computer" on page 19 for instructions.
password for one boot cycle.
Note: You can now start the computer one time without having to use the user
password, but if you do not use the Configuration/Setup Utility program
to change or delete the password, the next time you start the computer,
the original user password will be reinstated.
CMOS
clear jumper (JP3)
Chapter 3. Configuring your computer
25