Setting The Address Jumper (Jl) - IBM RT PC Options Installation

TNL SN20-9864 (May 1987) to 75X0217
Setting the Address Jumper (Jl)
J1
JumperJ1
Primary
~
Alternate
I···· U
The following table shows the address ranges provided by jumper J 1. If two
mM RT PC SCSI Adapters are used, one must be configured in the Primary
Jl position and the other in the Alternate Jl position. A single adapter may
be configured for either address range.
Note: Ensure that address ranges do not conflict with other adapter
options. Refer to "Conflicting Memory Addresses" on page 1-19 for more
information.
Jl Position
Address Range
Primary
OD50 - OD5F
Alternate
0950 - 095F
Section 8. Additional Options 8-11