Figure 4-1 Automatic Windows Update Enabled Warning Message; Figure 4-2 Pending Reboot Error Message - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

I N S T A L L I N G T H E N V R S O F T W A R E
4
Overview
Be fore you Begin - Windows Updates
If Windows updates are enabled in your system, then
and the installation continues.
Figure 4-1
If any pending reboot is there due to windows updates, then
appears, and the installation stops. Please ensure that you reboot your computer after the
Windows updates are finished.
Figure 4-2
Note:
Be f or e y o u B eg i n - D i s a b l e D e fra g m e nt a t i o n
Before starting the installation of MAXPRO NVR, it is recommended that you disable
Defragmentation.
1.
2.
3.
4.
5.
72
Automatic Windows Update Enabled Warning Message
Pending Reboot Error Message
Ensure that services.msc console is closed before Installing or upgrading the
MAXPRO NVR.
Click Start -> Run -> type DFRGUI.
In the Disk Defragmenter dialog click Configure Schedule
Click to clear the Run on the schedule (recommended) check box.
Click Start, (Right-click) Computer-> Manage, select Task scheduler ->Task
scheduler library -> Microsoft -> Windows
ScheduleDefrag and then select Disable.
Perform the following steps to make changes in the Registry Settings to disable
defragmentation at boot time:
a. Open the Registry Editor. Navigate to HKEY_LOCAL_MACHINE>SOFTWARE>
Microsoft> Dfrg> BootOptimizeFunction.
b. Right-click on the keyword "Enable" and then click Edit..
Figure 4-1 warning message appears
Figure 4-2 error message
-> Defrag. Right-click on the
MAXPRO NVR 5.6 Installation and Configuration Guide