New Features In Nvr 5.5 - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

I N T R O D U C T I O N T O M A X P R O ® N V R
1
MAXPRO NVR Features
The below table details the Firmware version compatible with the NVR 5.6 Build 572:
Camera Firmware
Model Version
Equip S Series V2 Firmware version
Ultra 1.00000000.1
3.2.1.722
Low 8, 2019-04-23
Light Or above.
1.00000000.1
WDR 3.2.1.716
8, 2019-04-09
cameras
Or above.
The above Equip S Series V2 Firmware version supports the following features:
Suppor t for HRHQ104 DVR
NVR 5.6 supports HRHQ104/108/116 DVR (V1.00.00HW001.1.190422) as 4/8/16ch encoders
Suppor t for smooth Renderi ng at VMS
NVR 5.6 Build 570 installation is mandatory for smooth reverse playback in MAXPRO VMS.

New Features in NVR 5.5

Analytics Annotati ons Support
Camera built in Annotations feature helps to trace and locate the moving subjects in
live/recorded video and generates an alarm if intrusion or loitering is detected. After this
feature is enabled in NVR, subjects in video when found in Region Of Interest, is bounded by
rectangle box and on alarm conditions, it will be signified with a change in color of bounding
box.
Annotation support for Intrusion Trace and Loiter Trace in Live and Playback video is
supported with only Equip-S Series specific cameras
See
34
Web Onvif ISOM
Version Version
1.3.1,
16.1.2 2019-04-
805
21
1.3.1,
16.12 2019-04-
054
04
• New VA events added with Annotation support
• Xtralis IntrusionTrace™
• Xtralis LoiterTrace™
• Intrusion Detection
• Loitering Detection
• Trigger Line Detection
Note:
Annotation feature is supported only with Xtralis XO package.
• Profile -G Edge Sync recording
• Mulitcast
Annotations section on how to configure this feature.
Xtralis Xtralis Intrusion
Intrusion Loitering Detection
VA Packages
1.0.8,
1.01.19 1.01.19
2019-01-15
MAXPRO NVR 5.6 Installation and Configuration Guide
Loitering Trigger
Detection Line
Detectio
n
1.0.8
1.0.8,
2019-
2019-01-15
01-15