Adding Ip Cameras / Encoders; Figure 6-11 Camera Page - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

Adding IP Cameras / Encoders

MAXPRO NVR 5.6 Installation and Configuration Guide
The MAXPRO NVR Wizard automatically discovers Honeywell cameras in the network and
adds it to the MAXPRO NVR user interface. Alternatively, you can also discover and add all the
supported cameras in MAXPRO NVR in the Camera page.
To add IP cameras
1. Click the Configurator tab. The System page displays by default.
2. Click the Camera tab to open the Camera page
Figure 6-11 Camera page
Note:
All Honeywell cameras that are discovered and added using the MAXPRO NVR
Wizard appear in the Camera page when you first open it.
3. Click the Auto Discovery button, the Auto Discovery screen is displayed.
• Click Start Discovery to discover the cameras in the network. By default, the
cameras discovered are displayed under Cameras Discovered pane.
The cameras are added based on the IP range and Video Format settings. See the
Configuring the Auto Discovery Settings
Only device integrations with auto discovery support are discovered automatically in
the NVR. All other devices need to be added manually.
• To add only specific cameras, select the required camera check boxes and then
click Add Cameras. The selected cameras appear under the Camera pane.
Note:
The cameras added will have the default parameters for all their settings.
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
Figure 6-11.
section on page 146 for more information.
137