C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
To configure Panomorph settings
1.
Figure 6-23
2.
3.
Note:
Configuring Oncam Grandeye Cameras
The integration of the unique 360-degree Oncam Grandeye H.264 IP cameras in MAXPRO
NVR enables video surveillance, acquisition and tracking that identifies suspicious behavior
enabling the interrogation and verification of a potential threat. This in-turn provides the
necessary intelligence needed to make a measured response to any critical situation.
158
On the Camera page, for the required camera, click
camera properties pane see
Figure
Panomorph Settings
Under General > 360 Settings
•
Select the Enable Panomorph check box to enable the Panomorph feature.
•
Select the Mounting Position. You have three options to choose from: Wall, Ceiling,
and Ground.
•
Select the Mode for the camera. The available modes are PTZ Mode, Quad Mode,
and Perimeter Mode. The default mode is PTZ Mode.
•
Select the Lens ID for the camera. The supported lens ids in v3.5 or later are A0**V,
A0IFV, A0NKV, A1UST, A8TRT, B0QQV, B4QQV, B5SST, B6SST and B8QQT. By
default AO**V Lens ID is selected. For Sony 360 camera the A8TRT lens ID is
selected automatically.
Click Save.
•
To view live video from Immervision certified cameras, Refer Video Viewing
Options from Immervision Enabled Cameras section in
Operator's Guide .
•
The recommended Aspect Ratio for Immervision Certified cameras is 4:3.
on the left corner to open the
6-12.
MAXPRO NVR 5.6 Installation and Configuration Guide
MAXPRO® NVR