Connecting A Pre-Main Amplifier (Zone 3) - Pioneer SC-LX904 Instruction Manual

Connecting a Pre-main Amplifier (ZONE 3)

ZONE B
(LINE OUT)
a
LINE
IN
Premain Amp.
a Analog audio cable
Contents
ARC
eARC
HDMI OUT 4K HDR
4K HDR
a
BD/DVD
Connections
≫
You can enjoy 2-ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog cable to
5 V 500 mA connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplifier or power amplifier in the separate room. The same source
USB
can be played back in the main room and ZONE 3 simultaneously. Also, different
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 3, use
an analog audio cable for connection. Note that ZONE 3 output is not possible
with the connection using a HDMI cable, digital coaxial cable, or digital optical
cable.
Setup
• This function can be used when any of the combinations among 2.1 ch, 3.1
ch, 4.1 ch, 5.1 ch, 6.1 ch 7.1 ch, 2.1.2 ch, 3.1.2 ch, 4.1.2 ch, and 5.1.2 ch in
"Speaker combinations" (
• When connecting the power amplifier, set "Multi Zone" - "Zone 3" - "Output
Level" ( p175) to "Variable" on the System Setup menu. If it is not set,
a large volume is output and the power amplifier, speakers, etc. may be
damaged.
86
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫ ≫
p75) is used.
Setup
≫