Step 1: Prepare The Site For Srx5400 Services Gateway Installation - Juniper SRX5400 Getting Started Manual

Table 1: Possible System Configurations (continued)
Component
Routing Engine
NOTE: For SPCs and MPCs, there are three slots available allowing for the following SPC and MPC
configuration scenarios: 1 SPC and 1 MPC, 2 SPCs and 1 MPC, or 1 SPC and 2 MPCs.
NOTE: MPCs are the only interface cards supported by the SRX5400 Services Gateway. The
SRX5400 Services Gateway does not support the IOCs or Flex IOCs supported on other services
gateways in the SRX5000 line.
Four AC power supplies (PSUs) provide full power redundancy. Each AC power supply provides power to
all components in the device. When two or more power supplies are present, they share power almost
equally within a fully populated system. However, if using only two AC PSUs, you must insert them into
the first and third PSU slots. In the DC configuration, two power supplies are required to supply power to
a fully configured device.
For detailed information about the SPCs, MPCs, and other cards supported by the services gateway, see
the SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
The services gateway is shipped in a cardboard box strapped securely to a wooden pallet. Plastic straps
secure the top and bottom in place. The services gateway chassis is bolted to this pallet. A printed copy
of this document and a cardboard accessory box are also included in the shipping container.
Step 1: Prepare the Site for SRX5400 Services
Gateway Installation
IN THIS SECTION
Rack-Mounting Requirements | 5
Tools Required to Unpack and Prepare the SRX5400 Services Gateway for Installation | 6
Minimum
1
at www.juniper.net/documentation/.
Maximum
1
4