1. Loosen hand screw A.
2. Adjust component to desired position.
3. Tighten hand screw.
5.10.3 Adjusting Cheek Supports
1. Push components inwards or pull components out to
desired position.
1541361-N
Fig. 5-20
Fig. 5-21
5.11 Adjusting Elan Headrest
The headrest clamp hardware is designed to install into
existing mounting holes in the backrest pan.
CAUTION!
Risk of injury during use of the mobility device
as a vehicle seat if a headrest is wrongly
adjusted or not installed
This can cause the neck to be hyperextended
during collisions.
– A headrest must be installed. The headrest
optionally supplied for this mobility device by
Invacare is perfectly suitable for use during
transport.
– The headrest must be adjusted to the user's
ear height.
Fig. 5-22
Setup
49