Seat Support; Adjusting Seat Width - Invacare FDX User Manual

Invacare® FDX®
CAUTION!
Risk of injury! When the tray is raised it does
not lock in place in this position!
– Do not tilt the tray up and leave it leaning in
this position.
– Never attempt to drive with the tray tilted up.
– Always lower the tray in a controlled manner.

5.14 Seat support

5.14.1 Adjusting seat width

Also refer to the following chapter entitled 5.14.2
Adjusting the seat depth, page 55.
The seat width can be adjusted in stages between
380 and 530 mm.
Tools:
• 4 mm Allen key
54
Fig. 5-29 Exploded drawing of seat support
1. Remove the seat cushion.
2. Remove the cover plates (1).
3. Undo the two Allen screws (6) at the rear on the
crossmember and remove them.
4. Undo the two Allen screws (9) at the front on the seat
support plate and remove them.
5. Loosen the four Allen screws (7) and (8) which are
located at the front and back to the sides of the seat
support plate to release tension so that the plate can
be moved more easily. Do not, however, remove these
screws completely.
1541361-N