Adjusting The Trunk Support (Easy-Adapt Seating System) - Invacare FDX User Manual

1. Using hardware provided, align and install headrest
clamp assembly into existing mounting holes in backrest
pan A.
2. Install headrest pad (not shown) to headrest rod using
mounting hardware provided.
The headrest pad can be adjusted to any desired
angle via the pivot ball at the end of the
headrest rod by loosening and tightening the
mounting hardware.
3. Loosen and remove lower D-Ring E from hardware.
4. Slide vertical mounting post B into clamp assembly
and adjust overall height of headrest pad to desired
position. Tighten knob D.
For proper set-up headrest should be adjusted to user's
ear height.
5. Adjust upper D-Ring C as required.
6. Once final height position is set, adjust lower D-Ring E
so that it rests flush with bottom of clamp assembly
(to prevent slipping).
Adjusting Depth and Angle
The headrest can be further adjusted for depth and angle
via the articulating hardware.
• 4 mm Allen key
• 5 mm Allen key
1541361-N
1. Loosen screws and clamping levers of dual link
adjustment assembly A and screws of upper and lower
rotational pivots B.
2. Adjust component to desired position.
3. Tighten screws and clamping levers.
5.12 Adjusting the trunk support (Easy-Adapt
seating system)
The trunk supports can be adjusted in width, height and
depth.
Fig. 5-25
Setup
51