Setting Contents And Code No. For Indoor Units - Daikin VRV IV-S RXTQ-TAVJU Series Service Manual

Field Setting from Remote Controller
2.3

Setting Contents and Code No. for Indoor Units

Mode First
No. Code
(∗2) No.
10(20) 0 Filter contamination heavy/light
(Setting for display time to clean air
filter)
(Sets display time to clean air filter
to half when there is heavy filter
contamination.)
0 (∗6) Filter Sign Setting
1 Long life filter type
1 (∗6) Filter cleaning sign time (Light/Heavy)
2 Room temperature thermistor in remote
controller
Remote sensor and remote controller
2 (∗6)
thermistor
3 Display time to clean air filter calculation (Set
when filter sign is not to be displayed.)
6 Remote controller thermostat control during
group control
7 Auxiliary electric heater ON/OFF temperature
Auxiliary electric heater ON temperature: Ttson
1
(∗8)
Auxiliary electric heater OFF temperature:
2
Ttsoff (∗8)
3 Setting the airflow rate when heating
6 Setting the rate of human detection
11(21)
7 Airflow adjustment
8 Compensating the temperature around people
9 Compensating the floor temperature
12(22) 0 Optional accessories output selection (field
selection of output for adaptor for wiring)
1 External ON/OFF input (Set when ON/OFF is
to be controlled from outside.)
2 Thermostat differential changeover
(Set when remote sensor is to be used.)
3 Airflow setting when heating thermostat is OFF
4 Automatic mode differential
5 Power failure automatic reset
6 Airflow setting when cooling thermostat is OFF
83
Description
Ultra
long life
filter
Long life
filter
Standard
filter
Second Code No.
01 02
Light Approx. Heavy Approx.
10,000
hrs.
Approx. Approx.
2,500
hrs.
Approx. Approx.
200 hrs. 100 hrs.
Light Heavy
Long life filter Ultra long life filter
2,500/1,250 10,000/5,000
Remote
controller + Only suction air
Suction air thermistor
thermistor
Only remote
Both
sensor thermistor
Display No display
Remote Remote
controller controller
thermostat thermostat
control is not control is
permitted permitted
Refer to page 88.
Refer to page 88.
Standard Slightly
increased
High sensitivity Low sensitivity
OFF Completion of
airflow
adjustment
Suction air Priority given on
temperature only the suction air
temperature
–4°C –2°C
(–7.2°F) (–3.6°F)
Refer to page 90.
Refer to page 90.
1°C 0.5°C
(1.8°F) (0.9°F)(∗7)
LL Set fan speed
Refer to page 91.
Not equipped Equipped
LL Set fan speed
: Factory setting
03 04
— —
5,000
hrs.
1,250
hrs.
—
—
—
Only remote
controller
thermistor
Only remote
controller
thermistor
—
—
Increased
Standard Infrared
sensitivity presence
sensor
disabled
Start of
airflow
adjustment
Standard Priority given
on the floor
temperature
0°C +2°C
(0°F) (+3.6°F)
—
—
—
—
SiUS331604E
Details
No.
(1)
—
— (2)
—
— (3)
—
— (4)
— (5)
(6)
(7)
—
(8)
— (9)
(10)
(11)
(12)
(13)
— (14)
— (15)
(16)
— (17)
— (18)
Field Setting