Daikin VRV IV-S RXTQ-TAVJU Series Service Manual page 106

Field Setting from Remote Controller
(21) Swing Pattern Settings
(In case of an infrared floor sensor is installed)
Set the flap operation in swing mode.
With the factory swing, flaps facing each other are synchronized to operate, and flaps placed side by side are set
to swing in an opposite direction to agitate airflow to reduce temperature irregularity.
Conventional swing operation (all direction synchronized swing) can be set onsite.
Mode No.
13 (23)
(22) Operation of Downward Flow Flap
Only the model FXEQ has the function.
When only the front-flow is used, sets yes/no of the swing flap operation of down-flow.
Mode No.
13 (23)
(23) Setting Airflow Position
Make the following airflow direction setting according to the respective purpose.
Mode No.
13 (23)
∗ Some indoor unit models are not equipped with draft prevention (upward) function.
(24) Setting of the Static Pressure Selection (for FXDQ model)
Model No.
13 (23)
93
Second Code
First Code No.
No.
01
2 02
03
Second Code
First Code No.
No.
01
3
02
Second Code
First Code No.
No.
01
4 02
03
Second Code
First Code No.
No.
01
5
02
Contents
All direction synchronized swing
—
Facing swing
Contents
Equipped
Not equipped
Contents
Upward (Draft prevention)
Standard
Downward (Ceiling soiling prevention)
Contents
Standard (FXDQ07-12: 10 Pa (0.04 inWG),
FXDQ18/24: 30 Pa (0.12 inWG))
High static pressure
(FXDQ07-12: 15 Pa (0.06 inWG),
FXDQ18/24: 45 Pa (0.18 inWG))
SiUS331604E
Field Setting