Oven Removal And Replacement - Amana AO27DG Service Manual

Installation Instructions
visible in the rear wall of oven.
3. Locate and remove the #59 LP gas spud wired to
the inlet pipe.
Gas Supply Connection
4. Use a 5/16-inch nut driver and remove the #52 natu-
ral gas spud from each oven. Save for future conver-
sions. Wire the #52 natural gas spuds to the inlet
pipe.
5. Install the #59 LP spud in the orifice opening.
6. Reinstall the broiler burner using the screws re-
moved in step 1.
The broil burner flames are not adjustable because the
burner is equipped with a fixed orifice. The burner does
not have an air shutter.
Bake burners are rated at 14,000 BTU for LP gas and
15,500 for natural gas. Broil burners are rated at 12,000
BTU for LP gas and 12,000 BTU for natural gas.

Oven Removal and Replacement

1. Turn off electrical and gas supplies.
2. Remove control panel and timer.
3. Disconnect gas connection.
4. Pull the oven forward out of the opening.
5. Unplug power cord.
6. Replace the oven using directions outlined earlier in
this section.
13 RA233001 Rev. 3