Converting Bake Burners; Converting Insta-Broil Burners - Amana AO27DG Service Manual

Installation Instructions
1. Remove cap marked "Nat."
2. Reverse cap. "LP" now appears on cap.
3. Reinsert cap. Do not disturb spring beneath the
cap. Verify fiber washer is correctly placed between
cap the regulator body.
Important Note: Some models may not have
washers. If washer is not supplied, none is needed.
Example Four
1. Remove cap with screwdriver slot.
2. Reverse and replace cap. Verify "LPG10" is visible.
Do not disturb spring beneath cap.
Example Five
1. Remove cap with screwdriver slot.
2. Remove black insert marked "NAT" from cap. (Insert
fits tightly in cap.)
3. Reverse insert.
4. Replace in hole. Verify "LP" is visible. Verify that
insert is pressed firmly into shoulder. Do not disturb
spring in regulator body.
5. Replace cap in regulator body and tighten.
Example Six
RA233001 Rev. 3
1. Remove cap with screwdriver slot.
2. Remove spring and washer. Washer will be at bot-
tom of spring as illustrated below.
3. Reverse to bring washer to the top.
4. Reinstall spring and washer.
5. Tighten cap.

Converting Bake Burners

The bake burner is behind the horizontal trim on the
front of the unit below each oven door.
1. Remove oven doors by lifting them up and off the
unit.
2. Remove screw under the plastic door latch knob.
Lift off the plastic knob (applies to upper oven only).
3. Remove three screws securing the trim below the
oven doors. Remove the trim.
4. Locate the oven burner orifice hood. The orifice hood
is brass and protrudes into the oven burner air shut-
ter.
5. Turn the orifice hood down onto the pin, approxi-
mately 1-1/2 to 2 turns. Do not overtighten the hood.
Overtightening may distort the hole.
6. Adjust the air shutters to a 11/16-inch opening.
7. Reassemble trim and latch knob. Check burners for
proper flame appearance.
Important Note: The air channel must be in place be-
fore operating the oven.

Converting Insta-Broil Burners

The broil burner spuds must be changed from a natural
gas spud to an LP spud. Both upper and lower oven
broilers must be converted.
1. Remove screw securing broiler burner to the oven
cavity at the front of the burner.
2. Remove the burner by gently pulling to left and
down. Be careful not to damage ignitor. Spud will be
12