Motor Error - Roland SOLJET PRO III XJ-540 Service Notes

6-8 MOTOR ERROR

NO CHECKING POINT
1 Media Jamming
Back tension of media is
2
too high
There is a dirt in teeth of
3
Drive Gear
Life of the Motor
4
Motor is broken
5 Broken Servo Board
Broken Power Supply for
6
Motor
ERROR DESCRIPTION
SCAN MOTOR ERROR
CODE :
Error detected as a result
MEANING
NO
Feed Motor Deviation Error
(The order from the CPU does not match
0001
the feedback of the Feed Motor.)
Feed Motor Overcurrent Error 1
(Big load is put on the motor movement
0004
instantaneously.)
Feed Motor Overcurrent Error 2
(A little load is put on the motor
0008
movement for a long time.)
0001 and 0004 occurred at the same
0005
time.
0001 and 0008 occurred at the same
0009
time.
Scan Motor Deviation Error
(The order from the CPU does not match
0010
the feedback of the Scan Motor.)
Scan Motor Overcurrent Error 1
(Big load is put on the motor movement
0040
instantaneously.)
Scan Motor Overcurrent Error 2
(A little load is put on the motor
0080
movement for a long time.)
0010 and 0040 occurred at the same
0050
time.
0010 and 0080 occurred at the same
0090
time.
ACTION
Remove cause of
Media Jam
Use appropriate Media
Clean Drive Gear
[3-4 CARRIAGE
Motor replacement MOTOR
REPLACEMENT]
Servo Board
replacement
Replace Switching [3-7 BOARDS
Power Supply REPLACEMENT]
0000 0000
Error detected at first
< External factors >
1. Media Jamming
2. Pull or Move the Carriage by hands.
3. Carriage runs into a thing/hands.
4. Media is stuck because it is caught by the paper pipe.
5. Media is pulled forcedly.
6. Too heavy media is loaded.
< Machine factors >
1. The grease lubrication of the motor gear is not enough.
2. Motor is broken or comes to its end of life
3. Servo Board is broken.
4. Head Carriage is not fixed to the belt firmly.
REFERENCE
When using hard-to-unroll or too heavy media, Motor Error occurs due
to the too much load for feeding the media.
When [MEDIA RELEASE] is enabled, the setting-media is fed
backward short distance to release the media stuck to the Print Heater
or Dryer before starting printing that may prevent the Motor Error.
When the Drive Gear has some dirt on its teeth and cannot rotate,
Motor Error occurs.
When the Motor is broken or reaches its life, the Motor cannot follow
the order from the CPU and it results in a Motor Error.
When the Motor Driver IC on the Servo Board is broken, the Power
Supply voltage for the motor is not supplied and the motor cannot
move. It results in the Motor Error.
When the Power Supply voltage for the Motor is not supplied, the
Motor cannot move and it results in the Motor Error.
6-5
OUTLINE
CAUSE