4-5 LIMIT POSITION & CUT DOWN POSITION INITIALIZE (Referential Time : 10min.)
This is for adjusting the relative distance between the Limit Sensor and the Capping Position, and also
detecting the distance from the Cut Down Position to the Limit Sensor after completing the adjustment.
When the Limit Position is not correctly set, it may cause some problems such as a head capping error. And
also, if the Cut Down Position is not correctly set, it may also cause a cutter-down error when separating the
sheet.
Remove the Right I/S Cover, Front Cover and Right Inner
1
Plate.
Right Inner Plate has a small hook on its right
bottom and it is inserted to the lower cover.
Be cautious when removing it.
2
Turn on the Sub Power SW while pressing [ ], [ ] and
[ ] keys for LIMIT INITIALIZE mode.
Confirm the relative positions of Head and Cap, moving
3
the capping unit up and down with [
Align the guides on the both ends of the
Capping Unit with the guides on the both
ends of the Carriage.
Make sure not to move the Carriage when the
Capping Unit is up because the heads could
be broken by touching the Capping Unit.
Front Cover
] and [
] keys.
4-36
Right I/S Cover
Right Inner Plate
+
LIMIT INITIALIZE
MENU
MOVE TO CAP POS