Siemens SINUMERIK 840D sl Function Manual page 42

2 Machine information
2.2 Variable monitors – time Series – measurements and measurement series
Changing the characteristic
Fig. 2-23: Drop-down list box for circularity test characteristics
The drop-down list box contains the list of characteristics for each test type. If you
select a characteristic, the diagram that has been displayed up to this point will be
replaced by the time series diagram for the characteristic selected.
"Actions" menu
Entries menu
Reload
All parameters
Scaling
Delete
measurement
"Display" menu
The display settings of the diagram can be influenced via the "Display" menu.
Fig. 2-24: Display settings
Function
Display all
Between markings
2-42
Regenerates the diagram.
A table containing the parameters for all of the
measurement series shown in the diagram is displayed.
Selection of the diagram scale (only for the equability
test). In the case of the diagrams for the circularity test
and universal axis test, the "Actions" menu does not
contain "Scaling".
See Section:
Equability test
Deletes the data points in a specified interval or value
range.
Description
Displays the complete progression over time of the
time series.
Displays the time range between the two markings.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
03/2013