Siemens SINUMERIK 840D sl Function Manual page 179

03/2013
Function
Data type
Comment
Add
Fig. 3-62: PLC trace: Defining recording parameters
Function
"Recording" tab
Pretrigger
Recording time
Absolute address
Comment
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Description
All simple file types are supported.
Note:
The addresses can be entered in German and
English notation. For example:
E1.1 or I1.1
Enters a comment for the absolute address.
Add additional PLC variable.
Description
Entry for the number of cycles for the pre-trigger,
used to determine the number of cycles before the
trigger event to be recorded.
Configured recording time, with the specified
number of PLC cycles for the entire recording and
the specified number of cycles from the time prior to
the trigger event that are to remain recorded.
Shows the PLC variables with absolute addresses
(not symbolic addresses), which are to be recorded
in the trace, or for which additional programming
can be carried out.
Note:
The PLC variables to be recorded are selected in
the same way as PLC triggers/conditions.
See also Section: Machine trigger on "PLC
variable"
Enters a comment for the absolute address.
3 Setting up functions
3.4 Fault Services
Type
INPUT
DISPLAY
INPUT
ACTION
Type
TAB DISPLAY
INPUT
(Digits from
0 to 9999)
TAB DISPLAY
INPUT
(Digits from 1
to 9999 for the
total number of
cycles, 0 also
permissible for
pre-trigger)
TAB DISPLAY
INPUT
S7 syntax
S7 formats
(max. 40
characters for
naming, all
characters are
permissible)
INPUT
3-179