Siemens SINUMERIK 840D sl Function Manual page 109

03/2013
Availability and privileges
Test series can only be configured on the PC. The authorization required for
configuring the test series is described in detail in the Appendix.
Saving axis test data
Depending on the setting in the organizational data, changes can be made to the
data relevant for the axis test (prolog and epilog, as well as parameters) while
retaining the identifier for an already successfully performed manual axis test. In
this case, activate the checkbox and click "OK".
If the checkbox is not set and you click "OK", the identifier for the performed axis
test is reset. It must be performed manually again.
The following prompt is displayed if a manual axis test is not performed after
changes in the prolog and epilog:
Fig. 3-17: Prompt after changes in the prolog and epilog
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3.2 Configuring measurements and measurement series
3 Setting up functions
3-109