Siemens SINUMERIK 840D sl Function Manual page 175

03/2013
Fig. 3-60: Feedback messages to the PLC in SINUMERIK standard DB10
Function
Configuration
of the PLC
settings
Configure data block addresses as required
Write data
Delete (all)
OK
Cancel
The feedback messages to the PLC can be described once for each control
monitor. It displays the variables in the way they are configured and named for the
return messages. SINUMERIK Integrate permits describing the variables in the
configured format only.
It is possible to switch directly to the settings menu from here in order to adjust and
configure the variable format.
Note
Variable format settings can only be changed if none of the control monitors are
writing to the variable in the set format. Any feedback messages being written
must be removed before the format can be changed.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Description
The PLC settings can be configured with the
selection field.
Switch to the menu for the configuration of the
feedback signals.
The following columns are displayed:
• DB
• S7 data type and format
• Name
• Write data
Specify data for feedback.
The following formats are available:
SINUMERIK, DB10, 4 bytes (118-121)
OR
In freely selectable DB, 8 bytes.
Note: Observe the identifier before and after the
feedback bytes.
Delete all freely configured variables from the list.
A prompt to confirm the deletion is displayed.
Acknowledge with "OK". The complete list is
deleted.
- OR -
Acknowledge with "Cancel". Without deleting, the
list of feedback messages is opened again.
The entries are accepted and the window is
closed.
The entries are accepted and the window is
closed.
3 Setting up functions
3.4 Fault Services
Type
SELECTION
Menu
change
DISPLAY
INPUT
ACTION
ACTION
ACTION
3-175