Siemens SINUMERIK 840D sl Function Manual page 182

3 Setting up functions
3.4 Fault Services
Function
Data block
No.
Start byte
Number of
bytes
Function description "Trigger variable monitor(s)"
Using the "Trigger variable monitor(s)" action, the variables configured in the
selected variable monitors are read from the control and uploaded. In order to
execute variable monitors as an action in a control monitor, they must have been
configured beforehand. All configured variable monitors are offered for selection
here.
Fig. 3-65: Variable monitors - list view
Function
Trigger variable
monitor
The configuration of variable monitors is described in the Section: Configuring
variable monitors.
3-182
Description
Number of the data block that is loaded onto the
server.
Start byte as of which the data of the data block will
be loaded (inclusive).
Number of bytes loaded from the start address.
Description
At the trigger event, the variable monitor
acquires the variables that are configured in
the variable monitor.
In addition to a label indicating that they
have been selected, the background of each
variable monitor is highlighted in yellow.
Labels show detailed information for each
variable monitor that is described in the
configuration of the variable monitors.
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
© Siemens AG 2006-2013 All Rights Reserved
03/2013
Type
DISPLAY
INPUT
(Digits from 0
to 9999)
DISPLAY
INPUT
(Digits from 0
to 999,999)
DISPLAY
INPUT
(Digits from 0
to 999,999)
Type
SELECTION