Avaya J169 Installing And Administering page 26

Initial setup and connectivity
Note:
The Ethernet speed is the LAN interface speed for both the phone and any attached
computer, if the administrator has not disabled the latter interface by a PHY2STAT
setting.
Important:
When you press the star (*) after the system displays a * to program message. The
initialization process can support an interrupt that invokes the Craft Access entry
procedure to allow manual settings, only if the local dialpad procedure status
(PROCSTAT) system value is 0. The zero PROCSTAT value provides full access to
local procedures. If PROCSTAT is 1 the Craft Access entry procedure can be invoked
only when a * to program message displays, but only the VIEW procedure is
available.
5. The IP phone sends a request to the DHCP server and invokes the DHCP process.
The phone displays one of the following messages:
• DHCP: s secs * to program
• DHCP: s secs VLAN ID = n
where s is the number of seconds that have elapsed after the DHCP process was started.
The phone displays the first message if 802.1Q tagging is off and access to local
programming procedures is not disabled or restricted. The phone displays the second
message if 802.1Q tagging is on and access to local programming procedures is disabled
or restricted. If the first and second message alternate every 2 seconds, 802.1Q tagging is
on. When the phone displays both messages alternately, access to local programming
procedures is not disabled or restricted.
6. The system determines the DHCP protocol , IPv4 or IPv6 protocol, and the applicable
parameters that are enabled.
Important:
IPv6 operation is limited to a specific customer set and not for general use.
Note:
The IPV6STAT parameter overrides both the DHCPSTAT parameter setting and
manual programming.
The DHCP server provides the IP addresses for the following hardware:
• The phone
• The HTTP/HTTPS server
• The TN799C or D Control-LAN (C-LAN) circuit pack on the media server
7. Using the list of gateway IP addresses provided by the DHCP server, the phone performs a
router check. The phone cycles through the gateway IP addresses with ARPs or pings until
it receives a response. When the router is located, the router processes the received LLDP
TLVs. Then the HTTP process starts.
May 2018 Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
26