Avaya J169 Installing And Administering page 109

Parameter name
CALCSTAT
CALLCTRSTAT
CALLAPPRSELMODE
CALL_LOG_JOURNAL
CLBACKUPTIME
CLBACKUPTIMESTAT
May 2018
Default value Description and value range
• 2: The idle call label is presented independent on call
1 Applies only to deskphones running software Release 6.0
and later. Specifies whether the Calculator application
must be displayed or enabled. Valid values are: 1=Yes,
enable the Calculator application, 0=No, disable the
Calculator application.
0 Applicable only to Call Centers. Call Center functionality
flag. 1 ASCII numeric digit. Valid values are: 0 = Call
Center functionality does not apply; do not provide
access to call center options/functions. 1 = Call Center
functionality applies; allow agent access to call center
functions like greetings and data backup.
0 Controls highlighting of a call appearance during an
incoming call. This parameter is applicable only if the
deskphone is registered to Communication Manager.
Valid values are:
• 0: The call appearance of the incoming call is
• 1: The highlight of the call appearance is on the active
0 Valid values are 0 or 1
Value of 1 triggers restore of call log journal.
15 Specifies the minimum interval, in minutes, between
backups of the Call Log, if the values of LOGBACKUP
and CLBACKUPTIMESTAT are both 1. Valid values are 1
through 60.
0 Specifies whether Call Log entries will be backed up only
after a minimum interval as specified by the value of
Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
Administering Deskphone Options
the left column in half width screen. "a." to "z." are
added to bridged and line appearances according to the
bridged or line button order.
states as in 1, but without addition of "a." to "z."
lowercase (and then "A."-"Z.") strings. If personalized
label is configured for line/bridged appearance then it
will be used instead of the idle call label assigned by
the Communication Manager.
Note:
This parameter is soft persistent.
highlighted. The softkeys for the incoming call are
displayed. For example, Answer or Ignore, if no other
call is active; Ans Hold, Ans Drop, or Ignore, if a call is
active.
call or call on hold. The softkeys for the hold call are
displayed, and not for the incoming call.
Table continues...
109