Avaya J169 Installing And Administering page 117

Parameter name
LEDMODE
LLDP_XMIT_SECS
LOCALZIPTONEATT
LOGBACKUP
LOGLOCAL
May 2018
Default value Description and value range
characters. The file name must end in .txt. The default is
a null string. Example: SET LANGSYS
mlf_german.txt
0 Supports new LED behavior Valid values 0= Old
behavior, and would mean that the red led is controlled
locally by the phone, 1=New behavior and would mean
the buttons red LEDs are controlled by CM .
Example: If new behavior is activated, Button module and
phone LEDs are aligned and will change according to call
state.
30 Specifies the rate in seconds at which LLDP messages
will be transmitted.
Valid values are 1 to 4 ASCII numeric digits, "1" through
"3600"
Main usage is for the SSO application to discover the
phone faster.
35 Controls the local phone ziptone volume when
AUTOANSSTAT= 1 Note: If Auto answer is configured on
the CM and not using the AUTOANSSTAT setting, this
parameter does not influence that zip tone volume.
Valid values: 0-95 where 0= Loudest and 95= Lowest.
1 Indicates whether the call log of the user should be
backed up. Values are: 1=Yes. The Call Log is backed up
to the same backup file as all other user data subject to
normal administration of that file. 0=No.
0 Event Log Severity Level. Valid values are one 0-8 ASCII
numeric digit. Controls the level of events logged in the
endptRecentLog and endptResetLog objects in the
SNMP MIB. Events with the selected level and with a
higher severity level are logged. Valid values are:
0=Disabled, 1=emergencies, 2=alerts, 3=critical,
4=errors, 5=warnings, 6=notices, 7=information,
8=debug.
Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
Administering Deskphone Options
Note:
This parameter applies only if the user has not
changed the Screen & Sound Options from the
deskphone menu. The changes made by the user
are stored in the backup/restore file as LANGUSER,
if BRURI has a valid value. The value of the
LANGUSER parameter in the backup/restore file
takes precedence over the LANGSYS parameter.
User can use the Clear operation to reset the
configuration.
Table continues...
117