Accessing Local Craft Procedures - Avaya J169 Installing And Administering

H.323
Hide thumbs Also See for J169:
Table of Contents

Advertisement

Initial setup and connectivity
Administrative Procedure. The administrator may grant the VPN user permission to change VPN
settings or only to view the settings.
Caution:
Only trained installers or technicians should perform local administrative procedures. Perform
these procedures only if instructed to do so by the system or LAN administrator. Static
administration of these options causes upgrades to work differently with static administration
of these options than by dynamic administration. Values assigned to options in static
administration do not change with upgrade scripts. These values remain stored in the phone
until one of the following happens:
• You download a new boot file
• You reset the IP phone.

Accessing local Craft procedures

Note:
In addition to the procedures listed here, the administrator may allow access to only the VPN
procedure, by setting the VPNCODE parameter in the settings file. For more information on
access to VPN-only Local Administrative Options, see VPN Setup Guide for 9600 Series IP
Telephones, 16-602968.
When you set PROCSTAT to 0, you have full access to local Craft procedures and you can invoke
local craft procedures during initialization or whenever the deskphone displays this message:
* to program
You can also initiate the Craft procedure at any other time the initialization process can support a
processing interrupt. If you set PROCSTAT to 1, the system allows access only to the VIEW craft
procedure for debugging purposes. You can invoke local Craft procedures only when the "* to
program" message displays during initialization.
Note:
The system supports the * to program message is supported even if the value of
PROCSTAT is 1, when the messages Address conflict, Subnet conflict, Bad
router? and Bad FileSv address display. You can gain execute the Craft procedures in
response to these messages as the situations requires corrective input.
Note:
The factory-set default Craft Access Code (PROCPSWD) is 27238.
May 2018
Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
30

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

J179

Table of Contents