Clearing The Phone Settings - Avaya J169 Installing And Administering

Initial setup and connectivity
To change the 802.1Q
value
To change the VLAN ID
value
To change the VLANTEST
value
4. Press Save to store the new setting and redisplay the ADDR screen or Cancel to return to
the ADDR screen without saving the value entered.
Once the new values are stored, the phone resets automatically.

Clearing the phone settings

About this task
Sometimes, you might want to remove all administered values, user-specified data, and option
settings and return a phone to its factory settings. You might have to remove all administered
values when you give a phone to a new, dedicated user and when the LOGOFF option is not
sufficient. For example, a new user is assigned the same extension, but requires different
permissions than the previous user.
The CLEAR option erases all administered data—static programming, HTTP and HTTPS server
programming, and user settings including Contact button labels and locally programmed Feature
button labels, and restores all such data to default values. Using the CLEAR option does not
affect:
• The software load. If you upgrade the phone, the phone retains the latest software. After you
clear a phone of the settings, you can administer the phone normally.
• The user configuration stored in backup/restore file server.
Caution:
This procedure erases all administered data without any possibility of recovering the data.
Neither the boot code nor the application code is affected by this procedure.
Use the following procedure to clear the phone of the administrative, user-assigned, and options
values.
Procedure
1. Select CLEAR from the Craft Procedures menu.
The phone prompts for confirmation.
May 2018
To enter an IP address in IPv6 format, use the dial pad in numeric-
only mode entry. For example, pressing button 2 initially enters a 2,
followed by A, B, C, and back to 2. Pressing button 3 initially enters
a 3, followed by D, E, F, and back to 3.
Proceed to the next step.
Use the Right navigation arrow to navigate through the text strings
corresponding to the L2Q values defined as Auto if L2Q=0, On if
L2Q=1, and Off if L2Q= 2 until the text string of the value you want
to change to displays. Proceed to the next step.
Use the dial pad to enter the new static VLAN ID of from 0 to 4094,
inclusive. Proceed to the next step.
Use the dial pad to enter the new value of the DHCPOFFER wait
period of from 0 to 999. Proceed to the next step.
Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
38