Table of Contents
Advertisement
Commissioning, inspection, maintenance
Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Commissioning the system with the commissioning assistant.................................... 33
•
•
2. Filling the heating system................................................................................................. 36
•
3. Topping up the heating water........................................................................................... 38
•
•
•
4. Checking all connections on the heating water and DHW sides for leaks................... 38
•
5. Venting the heating system............................................................................................... 38
•
6. Checking the gas type....................................................................................................... 39
•
7. Converting the gas type for operation with LPG and natural gas M............................. 39
•
•
•
8. Removing the front panel.................................................................................................. 40
•
9. Moving the programming unit to the service position................................................... 41
•
•
•
10. Checking the static pressure and supply pressure........................................................ 41
•
11. Function sequence and possible faults........................................................................... 43
•
12. Setting the max. heating output........................................................................................ 44
•
13. Adjusting the pump rate of the integral circulation pump............................................. 44
•
14. Activating screed drying................................................................................................... 46
•
15. Tightness test on balanced flue system (annular gap check)....................................... 47
•
16. Removing the burner......................................................................................................... 47
•
•
17. Checking the burner gasket and burner gauze assembly.............................................. 49
•
•
18. Checking and adjusting the ignition and ionisation electrodes.................................... 50
•
•
19. Checking the back draught safety device........................................................................ 50
•
20. Cleaning the heating surfaces.......................................................................................... 51
•
•
21. Checking the condensate drain and cleaning the trap................................................... 51
•
•
22. Installing the burner........................................................................................................... 53
•
•
•
24. Checking the flow limiter (only for gas condensing combi boiler)............................... 54
•
•
•
25. Checking the expansion vessel and system pressure................................................... 54
•
•
•
26. Checking the safety valve function
•
•
•
•
•
•
28. Checking all gas equipment for tightness at operating pressure................................. 55
•
•
•
29. Fitting the front panel........................................................................................................ 55
•
•
30. Checking the combustion quality..................................................................................... 55
•
•
•
•
•
•
•
33. Matching the control unit to the heating system............................................................ 57
•
34. Adjusting heating curves.................................................................................................. 57
•
35. Calling up and resetting the service display................................................................... 57
•
36. Instructing the system user.............................................................................................. 57
32
Page
Hide quick links:
Advertisement
Chapters
Table of Contents
