To Verify Lan Communications - HP E3473A User Manual

To verify LAN communications

Verify your HP E3472A/73A Emulator is now active and on the
1
network by issuing a telnet to the IP address.
This connection will give you access to the HP E3472A/73A Emulator's
built-in terminal interface.
To view the LAN parameters, enter the lan command at the terminal
2
interface prompt.
To exit from this telnet session, type <CTRL>D at the prompt.
3
The best way to change the HP E3472A/73A Emulator's IP address, once it
has already been set, is to telnet to the HP E3472A/73A Emulator and use the
terminal interface lan command to make the change. Remember, after
making your changes, you must cycle power or enter a terminal interface
init -p command before the changes take effect. Doing this will break the
connection and end the telnet session.
If You Have Problems
If you encounter problems, refer to the "Solving Problems" chapter (page 99).
Example
$ telnet 192.35.12.6
R>lan
lan is enabled using TP
lan -i 192.35.12.6
lan -g 0.0.0.0
lan -p 6470
Subnet Mask: 255.255.255.0
Ethernet Address: 08000F090B30
Connecting to the Host Computer
To verify LAN communications
33