To Configure Lan Parameters Using "Ipconfig700 - HP E3473A User Manual

Connecting to the Host Computer

To configure LAN parameters using "ipconfig700"

To configure LAN parameters using "ipconfig700"
When you are using HP 9000/700 computer or Sun SPAPCsystem with HP
B3755A/56A installed in it, you can use ipconfig700 command to configure
LAN parameters.
The ipconfig700 command sets the IP address and gateway address for the
HP E3472A/73A Emulator. An IP address must be configured before a
network interface connection can be made.
The ipconfig700 command cannot be used if your workstation is running a
bootp daemon. If this is the case, use BOOTP to configure LAN parameters.
To determine if BOOTP is enabled on your computer, see "To configure LAN
parameters using BOOTP" in this chapter.
The following steps need to be taken when configuring the network
parameters with ipconfig700.
Connect the HP E3472A/73A Emulator to your network. This
1
connection can be made by using either the 10BASE-T connector or
the 10BASE2 BNC connector on the HP E3472A/73A Emulator.
Set the configuration switches to indicate the type of connection that
2
is to be made.
Switch S1 must be set to OPEN, indicating that a LAN connection is being
made. Switch S6 must bet set to OPEN, to allow programming of the LAN
parameters.
26