Table of Contents
Advertisement
Setting up the Emulator
Setting up the Emulator
C a u t i o n
To prevent the emulator and the target system from being damaged, be sure
to follow the cautions below when handling them.
•
When connecting/disconnecting the emulation controller and
emulation probe, first disconnect the power cable from the
emulation controller to stop supplying power and then the
emulation probe from the target system.
•
To prevent the emulator from being damaged by static electricity,
store and use the emulator in a place resistant to static electricity.
•
When supplying power to the emulator, check that the emulation
probe is plugged into the target system or demo board.
Before connecting the Emulator to the power supply, be sure to follow the
instructions below regarding the power cable.
The HP E3472A/73A Emulator is shipped from the factory with a power
supply and cord appropriate for your country. Use only the supplied HP
power supply and cord. Failure to use the proper power cable could result in
electric shock.
W A R N I N G
For protection from electrical shock, the power cable ground must not be
defeated.
The power plug must be plugged into an outlet that provides a protective
earth ground connection.
14
Advertisement
Table of Contents
