HP E3473A User Manual page 40

Connecting to the Host Computer
To configure LAN parameters using the built-in terminal interface
Once you have set a valid IP address, you can use the telnet utility to connect
to the HP E3472A/73A Emulator, and use the lan command to change LAN
parameters.
Example
For example, to assign an IP address of 192.6.94.2 to the HP E3472A/73A
Emulator, enter the following command:
R>lan -i 192.6.94.2
The IP address and any other LAN parameters you change are stored in
nonvolatile memory and will take effect the next time the HP E3472A/73A
Emulator is powered off and back on again.
See Also
"Solving Problems," page 103, if you have problems verifying LAN
communication.
25