Table of Contents
Advertisement
Solving Problems
To execute the built-in performance verification test
The tests available through this command can be displayed as follows:
c>pv -l
Testing: HPE3499A Series Emulation System
Test
1: Powerup PV Results
Test
2: LAN 10Base2 Feedback Test
Test
3: LAN 10BaseT Feedback Test
Test
4: Break In and Trigger Out BNC Feedback Test
Test
5: Target Probe Feedback Test
Test
6: Boundary Scan Master Test
Test
7: I2C Test
c>
On a good system, when the E3496-66502 loop-back board is plugged into
the 50-pin target connector, the RST LED will light and the BKG and USER
LEDs will be out.
The results on a good system are as follows:
c>pv 1
Testing: HPE3499A Series Emulation System
Test
1: Powerup PV Results
Test
2: LAN 10Base2 Feedback Test
Test
3: LAN 10BaseT Feedback Test
Test
4: Break In and Trigger Out BNC Feedback Test
Test
5: Target Probe Feedback Test
Test
6: Boundary Scan Master Test
Test
7: I2C Test
FAILED
Number of tests: 1
Copyright (c) Hewlett-Packard Co. 1987
All Rights Reserved.
written permission is prohibited, except as allowed under copyright laws.
HPE3499B Series Emulation System
Version:
A.01.00 17Aug96
Location:
Generics
c>
If a failure is found on one of these tests, details of Failure can be obtained
through using a verbose level of 2 or more.
110
Number of failures: 0
Reproduction, adaptation, or translation without prior
Passed!
Passed!
Passed!
Passed!
Passed!
Passed!
Passed!
Advertisement
Table of Contents
