Table of Contents
Advertisement
Output 19 Low not received on Input 11
Output 11 Low not received on Input 19
Output 13 Low not received on Input 1
Output 12 High not received on Input 6
Output 12 and Input 6 not pulled high on release
Output 8 Low not received on Input 10
Output 7 Low not received on Input 20
Output 4 Low not received on Input 14
Output 2 Low not received on Input 18
FAILED
Number of tests: 1
If the you get a verbose output like this, check to make sure that the self test
loop-back board was connected properly.
You can check the 50-pin ribbon cable by connecting it between the
N o t e
emulation controller and loop-back board and performing this test.
Test procedure for the emulation probe
Procedure
Dismount the power supply from the emulation controller.
1
Connect the emulation probe and the emulation controller.
2
Connect the 50-pin ribbon cable and AUX power cable.
Plug the demo board into the 177-pin PGA connector.
3
Set the DIP switch on the demo board to "TEST MODE."
4
Set all of the DIP switches to CLOSED.
5
This is standard RS-232 at 9600 baud which can be connected directly to a 9
pin RS-232 interface that conforms to the IBM PC-AT 9 pin standard.
Connect a coaxial cable between the BREAK IN and TRIGGER OUT
6
BNCs.
Connect the power supply to the emulation controller.
Enter the pv command through the terminal emulator.
8
After testing, return the DIP switch on the demo board to the"DEMO MODE."
The results on a good system are as follows:
c>pv 1
Testing: HPE3499A Series Emulation System
Test
1: Powerup PV Results
Test
2: LAN 10Base2 Feedback Test
Test
3: LAN 10BaseT Feedback Test
Test
4: Break In and Trigger Out BNC Feedback Test
Test
5: Target Probe Feedback Test
To execute the built-in performance verification test
Number of failures: 1
Solving Problems
Passed!
Passed!
Passed!
Passed!
Passed!
113
Advertisement
Table of Contents
