Solving Problems
Solving Problems
If you have problems with the HP E3472A/73A Emulation Probe
System, your first task is to determine the source of the problem.
Problems may originate in any of the following places:
•
The HP E3472A/73A Emulator itself
•
Emulation controller
•
Emulation probe
•
50-pin ribbon cable
•
The connection between the HP E3472A/73A Emulator and your
host computer
•
The interface software on the host computer
•
The connection between the HP E3472A/73A Emulator and the
target system
•
The target system
You can use several means to determine the source of the problem:
•
The status lights on the emulation controller
•
Error messages displayed on the host computer
•
Diagnostic tests performed using the host computer
•
HP E3472A/73A Emulator "performance verification" tests
You can run these tests for each of the emulation controller and emulation
probe.
100