SECTION 2 DISASSEMBLY PROCEDURES
6. Unscrew 1 screw-K, 4 screws-L and remove the liquid cooling tank support metal.
7. Unscrew 8 screws-M and remove the DMD radiator from the intake duct block.
8. Remove the DMD block/liquid cooling unit.
K L
M
M
K
L
DMD block/Liquid cooling unit
Liquid cooling support
metal
Liquid cooling support metal
4
Intake fan block
Intake duct block
DMD block/Liquid cooling unit
8
Intake 2 fan
Intake 1 fan
DMD fixing spring
DMD radiator pump
[Note on mounting]
• Apply the heat dissipation compound evenly to the rear
surface of DMD radiator pump.
• Take care not to stick out the compound.
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade 0.15g
DIS-27
<RZ31K/RS30K>
Ball point driver
[RD]-P.C.Board
[M1]-P.C.Board
3
[F]-P.C.Board
2