Panasonic PT-RS30K Service Manual page 52

SECTION 1 SERVICE INFORMATION
5. 3. System log data acquisition method
* The log data acquisition via LAN terminal or serial terminal.
5. 3. 1. Equipment to be used
1. Computer : Use it for the transfer of backup data.
2. Communication cable
Serial terminal connection
LAN terminal connection
3. Service Software : [DataLogBackup.exe] Please download the service software from the projector service Web (PASS).
5. 3. 2. Connection preparations
1. Check the settings of the projector.
Serial terminal connection
1) The [INPUT SELECT] of sub menu [RS-232C] must be set according to the connection method.
2) Check the RS-232C settings (ID, Baudrate and Parity) and take a note.
LAN terminal connection
1) The [DIGITAL LINK MODE] of sub menu [NETWORK], is select to [AUTO] or [ETHERNET].
2) Check the network IP address of the projector and take a note.
3) Set the IP address of computer to approximate value of projector IP address.
[Note] If you have changed the each menu settings, please return settings of the original (customers) after work.
2. Connect the projector and the PC by using a communication cable.
Serial terminal connection
Computer
Serial cable (RS-232C)
5. 3. 3. Acquisition of log data
1. Switch the projector to "Normal-Standby" mode (STANDBY/ON indicator is lighting in red).
2. Start up service software [DataLogBackup.exe] with a computer.
D-sub 9pin (male/female RS-232C straight)
LAN cable. (When connecting directly, use a cross cable)
Projector
SERIAL IN
LAN terminal connection
Computer
LAN cable (straight)
INF-42
<RZ31K/RS30K>
Projector
LAN
LAN cable (straight)