SECTION 3 ADJUSTMENTS
8. If the version of the software is correct click the [OK] button and start updating.
[Note]
• During updating, the LED indicators on the projector will light as the below
LDdriver
Formatter
DIGITAL LINK
9. After finishing the updating, the confirmation message is displayed. Click [OK] button.
10. Click [EXIT] button to quit the application.
* Restart the main power of projector, and check that the version of software is updated definitely
Display the sub menu [STATUS] form the main menu[PROJECTOR SETUP:] and confirm the version of each software. As
the software of DRC, Formatter, DIGITAL LINK, LD Driver are displayed in the service mode only, enter the service mode
first and check the version of them in the [STATUS] menu.
ON/STANDBY
Main
Lit in red
Sub
OFF
FRC
Lid in green
Lid in green
Lid in green
Lid in red
LIGHT1 LIGHT2
Blink in red each others
Lid in green (all)
Lid in red (all)
Lid in red (all)
Lid in red (all)
Blink in red each others
ADJ-21
<RZ31K/RS30K>
TEMP
OFF
OFF
Lid in red
Lid in red
Lid in red
OFF