Network Settings - Delta eZV-440 Application Manual

Network Settings

The following fields are found in the Network Settings section.
Field
Description
Name
Displays the controller's BACnet address. This field is read-only when the DNA
BACnet
box is checked. If you want to enter a new address, clear the DNA box.
Address
Click here
Displays the password that secures access to the controller's NFC chip. The
NFC
value range is 0 to 65535. The password is stored on the AV96 object.
Password
The Device Password field on the Delta Controls mobile applications must match
the NFC password before any data can be written to the NFC chip.
Turns on or off Derived Network Addressing (DNA) automatic addressing. DNA
DNA
is turned on when the box is checked; the BACnet address also becomes read-
only. To manually enter a new address, clear the DNA box.
Delta Controls products have the option to use DNA or Derived Network
Addressing, a system of organizing and configuring controllers in a network.
When DNA is enabled, addresses are automatically assigned to a device based
on the BACnet network type and the Delta Controls product type, so that a
device can work out-of-the-box without much set up.
NET1 Displays the network protocol currently enabled for the NET1 port. This is a read-
Protocol only field.
NET1 Displays the baud rate for the NET1 port. Any changes to the baud rate will be
Speed applied immediately to all Delta Controls controllers in the network.
NET1 Displays the controller's BACnet network number.
Number
NET1 Displays the controller's network address typically set up by the controller's DIP
MAC switches.
Address
NET2 Displays the network protocol currently enabled for the NET2 port. This is a read-
Protocol only field.
NET2 Displays the baud rate for the NET2 port. Any changes to the baud rate will be
Speed applied immediately to all Delta Controls controllers in the network.
eZV-440 Application Guide
Edition 2.6
for more information about the BACnet address object.
Page 23 of 84